Development of method and tools to replace motor in roof ventilation unit
Gullström, Ivar (2013)
Gullström, Ivar
Yrkeshögskolan Novia
2013
All rights reserved
Julkaisun pysyvä osoite on
https://urn.fi/URN:NBN:fi:amk-2013080614629
https://urn.fi/URN:NBN:fi:amk-2013080614629
Tiivistelmä
This thesis is done for Wärtsilä Power Plants. Before this thesis there was no developed method on how to change the fan motor in the roof ventilation unit in Wärtsilä’s power plants. The purpose of the thesis was to develop a method for this. The thesis work has been done by coming up with different ideas of how the replacement could be done. Then the ideas have, through discussions, been developed to a solution that meets the demands set by the employer. Development of a detailed instruction manual for the replacement work was also part of the thesis.
For the method to work, two special tools had to be developed. The tools were designed both through hand calculations and by the use of digital designing tools. Manufacturing and assembly drawings of the special tools were produced and became a part of the end product.
The result was a method of how to change the fan motor, as well as necessary tools and instructions for doing the replacement. The result of the thesis is a special solution explicitly for the use of the employer. Examensarbetet är gjort på uppdrag av Wärtsilä Power Plants. Innan detta examensarbete fanns ingen utvecklad metod för att byta fläktmotorn i takventilatorn på Wärtsiläs kraftverk. Målet med arbetet var att ta fram en metod för detta. Arbetet har skett genom att ta fram olika idéer hur bytet kunde gå till. Framtagna idéer har sedan, genom diskusioner, utvecklats till en lösning som passar de krav som ställts av uppdragsgivaren. Till arbetet hörde också att utarbeta en detaljerad instruktionsmanual som kan användas på plats under bytet av motorn.
För att den framtagna metoden skulle fungera krävdes att två specialverktyg utvecklades. Verktygen dimensionerades både med handkalkyler och digitala dimensioneringsverktyg. Tillverknings- och monteringsritningar av specialverktygen togs fram och blev en del av slutprodukten.
Slutresultatet blev en metod för att byta fläktmotorn, samt nödvändiga verktyg och instruktioner för att utföra detta. Resultatet av arbetet är en speciallösning explicit för uppdragsgivarens användning.
For the method to work, two special tools had to be developed. The tools were designed both through hand calculations and by the use of digital designing tools. Manufacturing and assembly drawings of the special tools were produced and became a part of the end product.
The result was a method of how to change the fan motor, as well as necessary tools and instructions for doing the replacement. The result of the thesis is a special solution explicitly for the use of the employer.
För att den framtagna metoden skulle fungera krävdes att två specialverktyg utvecklades. Verktygen dimensionerades både med handkalkyler och digitala dimensioneringsverktyg. Tillverknings- och monteringsritningar av specialverktygen togs fram och blev en del av slutprodukten.
Slutresultatet blev en metod för att byta fläktmotorn, samt nödvändiga verktyg och instruktioner för att utföra detta. Resultatet av arbetet är en speciallösning explicit för uppdragsgivarens användning.