Haku
Viitteet 19281-19290 / 19736
Nutrients and Organic Matter in Wastewater
(Tampereen ammattikorkeakoulu, 2013)
The aim of the project was to test if three different systems of treating wastewater were able to treat the wastewater from mineral processing , and if they were to reduce the amount of nutrients and organic matter in the ...
Preparing an Environmental Permit Application : Case Study for a Small Scale Fish Farm
(Tampereen ammattikorkeakoulu, 2013)
In 2011, approximately 10 million kg of rainbow trout were farmed in Finland, of which 1,6 million kg were farmed in inland water systems. The eutrophication of water systems caused by fish farming has decreased since the ...
Sustainable villages in northern conditions : review on sanitation alternatives in rural areas
(Tampereen ammattikorkeakoulu, 2008)
Mercury in Austrian Forest Soils : Within the Frame Work of BioSoil
(Tampereen ammattikorkeakoulu, 2010)
Mercury and its emissions have become a burning question. The purpose of this thesis is to report and discuss the results of the European Union’s BioSoil –project in Austria regarding mercury content in the forest soils. ...
Kaukojäähdytysverkon energiatehokkuuden parantaminen
(Tampereen ammattikorkeakoulu, 2018)
Tässä opinnäytetyössä perehdytään Tampereen Sähkölaitoksen kaukojäähdytysverkon alhaiseen paluulämpötilaan, tapoihin vaikuttaa sen lämpenemään sekä tutkitaan lämpenemän vaikutusta verkon energiatehokkuuteen. Työssä ...
Maapohjaisten suotovesialtaiden pohjamassojen haitallisten aineiden pitoisuuksien määrittäminen sekä jatkotoimenpiteet Tarastenjärven jätteenkäsittelykeskuksessa
(Tampereen ammattikorkeakoulu, 2013)
Tämä opinnäytetyö tehtiin yhteistyössä Pirkanmaan Jätehuolto Oy:n kanssa. Opinnäytetyön tarkoitus oli määrittää Tampereella sijaitsevan Tarastenjärven jätteenkäsittelykeskuksen kahden maapohjaisen suotovesialtaan ...
Further development of a solar thermal chamber dryer for fish : based on a previous device
(Tampereen ammattikorkeakoulu, 2018)
In this final thesis, a drying chamber has been developed, on the basis of a previous prototype. A new design has been drawn in Inventor 2018 and has been tested then in Autodesk CFD 2018, to figure out air flow problems ...
A study on life cycle assessment of dental prosthesis
(Tampereen ammattikorkeakoulu, 2008)
ISO 14001 -standardin mukaisen ympäristöjärjestelmän suunnittelu ja käyttöönotto
(Tampereen ammattikorkeakoulu, 2007)









