Drive interface study
Kallio, Toni (2014)
Satakunnan ammattikorkeakoulu
2014
All rights reserved
Julkaisun pysyvä osoite on
https://urn.fi/URN:NBN:fi:amk-2014052810616
https://urn.fi/URN:NBN:fi:amk-2014052810616
Tiivistelmä
Purpose of this thesis was to carry out pre-study for drive interface module, which will be placed between the control system of the elevator and the drive that runs the hoisting motor. Second topic was planning of reliability tests and performing of preliminary and noise tests for contactors and contactors relays used in drive interface modules today and for contactors and contactor relays which are planned to be used in upcoming module. Thesis was made for R&D department of KONE Oyj placed in Hyvinkää Finland.
On thesis electrical and mechanical requirements for design of the new module were determined. Also first mock-up version of the module was built from which basis building of new detailed module prototype could be started.
For contactors reliability tests, test environment was planned and built to KONE reliability laboratory premises in Hyvinkää. Testing will be started during summer 2014. Preliminary and noise tests were performed also in KONE testing premises in Hyvinkää.
Purpose of contactor tests was to compare characteristics of contactors used in drive interface modules today and contactors planned to be used in upcoming module and to ensure reliability level of those contactors before implementing them to production.
On thesis electrical and mechanical requirements for design of the new module were determined. Also first mock-up version of the module was built from which basis building of new detailed module prototype could be started.
For contactors reliability tests, test environment was planned and built to KONE reliability laboratory premises in Hyvinkää. Testing will be started during summer 2014. Preliminary and noise tests were performed also in KONE testing premises in Hyvinkää.
Purpose of contactor tests was to compare characteristics of contactors used in drive interface modules today and contactors planned to be used in upcoming module and to ensure reliability level of those contactors before implementing them to production.